Product Description
Roll pin
Frequently Asked Questions
Q: What is the purpose of a roll pin in electric lift truck applications?
A: The 0000-000652-00 roll pin is a spring-type fastener used to retain shaft collars, clevis pins, and link assemblies in lift truck steering, mast, and hydraulic actuator components. The rolled sleeve design creates spring pressure that locks against shaft diameters.
Q: What is the material and finish of the 0000-000652-00?
A: OEM roll pins for electric lift trucks are typically manufactured from spring steel with a zinc-plated or stainless steel finish. The zinc coating provides corrosion protection in standard warehouse environments. Stainless variants are used in wet storage or outdoor charging areas where moisture exposure is high.
Q: How do I remove and install a roll pin without damaging it?
A: Use a roll pin removal tool or small drift punch to tap the pin out from one end. Do not strike the pin directly with a hammer; use steady pressure with a punch to push it through the hole. When installing, insert the seam side (opening) first into the hole, then tap gently until fully seated and the component is locked.
Q: Can a roll pin be reused after removal?
A: Roll pins have a limited reuse life. After removal, inspect the seam for cracks or the body for permanent deformation. If the pin is bent, cracked, or the seam has opened up, discard it. Most technicians replace roll pins on first removal to avoid shaft damage from a loose or failing pin.
Q: What shaft diameters does the 0000-000652-00 accommodate?
A: Roll pin sizing varies by shaft diameter. The OEM part number 0000-000652-00 is used in specific Crown, Toyota, Raymond, or Hyster models with matching hole and shaft geometry. Verify the shaft diameter and hole size match your equipment before ordering. Undersized pins will slip; oversized pins will not fit.
