Product Description
Roll pin
Frequently Asked Questions
Q: What does this roll pin do in forklift equipment?
A: This roll pin (SKU 00591-73872-81) secures pivot joints, linkage connections, and mast guide assemblies in forklift mast sections and carriage mechanisms. It allows controlled movement during mast extension and load positioning while maintaining component alignment.
Q: What material is SKU 00591-73872-81 made from?
A: This forklift roll pin is manufactured from hardened steel alloy formulated to resist the higher shear stresses and dynamic loads encountered in powered lift equipment compared to manual pallet jacks.
Q: Which forklift manufacturers use this roll pin?
A: SKU 00591-73872-81 is compatible with forklifts from brands including Toyota, Crown, Hyster, Yale, Mitsubishi, Jungheinrich, Linde, Clark, and BT. Always confirm the journal diameter and mounting configuration match your specific forklift model and mast type.
Q: How does forklift duty affect roll pin replacement intervals?
A: Forklift roll pins experience higher cycle rates and heavier loads than manual pallet jack pins. Typical replacement is every 18-36 months under normal operation, or sooner if used in repetitive high-frequency cycles or adverse environments (cold storage, outdoor, wet floors).
Q: What wear indicators show that this roll pin needs replacement?
A: Replace this roll pin if you observe scoring, surface corrosion, visible spring tension loss, or play/looseness in the mast guide or linkage joint. Visible rust spots or pitting indicate the pin is compromised and should be replaced immediately to prevent catastrophic mast failure.
Q: Is this roll pin removable for maintenance?
A: Yes. SKU 00591-73872-81 is designed as a removable fastener for maintenance access to mast guide assemblies and linkage points. However, upon removal, replacement with a new roll pin is strongly recommended rather than reuse.