Retaining Ring for Pallet Jacks

Frequently Asked Questions

Q: What is the 3EC-13-11380 retaining ring used for?
A: The 3EC-13-11380 is a retaining ring (snap ring or circlip) used in manual pallet jack mechanical assemblies. Retaining rings hold components in place axially on shafts or in grooves, preventing them from sliding during operation or disassembly.

Q: What are the dimensions and design specifications?
A: Refer to the technical specification sheet for the exact bore diameter, ring thickness, and design type (internal snap ring, external snap ring, or E-clip) of the 3EC-13-11380. Correct dimensions are critical for proper fit and load retention.

Q: Which manual pallet jack components use this retaining ring?
A: The 3EC-13-11380 retaining ring may be used on wheel assemblies, pivot shafts, pump components, or hydraulic cylinders depending on pallet jack design. Confirm your equipment model and component assembly to identify the correct location and application.

Q: What material is this retaining ring made from?
A: Retaining rings are typically manufactured from spring steel or stainless steel. Verify the material composition to ensure corrosion resistance and adequate spring tension for your warehouse environment and storage conditions.

Q: Can a retaining ring be reused after removal?
A: Retaining rings should not be reused if they were deformed, bent, or lost tension during removal. A weak or distorted ring cannot maintain component retention and may fail during operation. Always replace with a new ring to ensure safe equipment performance.