Product Description
Pump and Motor Assembly, 24V
Frequently Asked Questions
Q: What is the BA 127532 pump and motor assembly used for?
A: The BA 127532 is a 24VDC pump and motor assembly designed for electric lift trucks and powered pallet jacks. This assembly converts electrical energy to hydraulic flow, enabling the hydraulic system to raise and lower the load. It fits Baker electric lift truck models and compatible material handling equipment requiring 24-volt pump motor operation.
Q: What are the electrical specifications of the BA 127532?
A: The BA 127532 operates at 24VDC nominal voltage. It draws current based on load and pump demand, typically ranging from 30 to 60 amps depending on hydraulic system pressure and flow requirements. This assembly is designed for deep-cycle forklift battery systems. Verify your truck battery voltage matches 24VDC before installation.
Q: What is the hydraulic flow capacity of the BA 127532?
A: The BA 127532 pump delivers hydraulic flow rated for standard Baker lift truck load speeds and lift capacity. Flow output varies with motor speed and load. Contact us with your equipment model and load capacity to confirm flow specifications. Do not install this pump in applications requiring higher or lower flow than the original equipment specification.
Q: What maintenance is required for the BA 127532 pump and motor?
A: The BA 127532 requires periodic hydraulic fluid inspection and level checks. Keep hydraulic fluid clean and at the correct viscosity grade specified in your equipment manual. Monitor for leaks around pump seals and hose connections. Do not attempt to repair pump internals; this is a sealed assembly. Replace if performance degrades or leaks develop.
Q: How do I know if the BA 127532 needs replacement?
A: Signs of pump or motor failure include loss of lifting speed, inability to reach full lift height, excessive noise or grinding, power draw at battery not increasing under load, or visible oil leaks from the assembly housing. If the truck is fully charged but the pump does not run, check the contactor, solenoid, and electrical connections before replacing the pump assembly.