HY 235596

Frequently Asked Questions

Q: What equipment does the HY 235596 bearing fit?
A: The HY 235596 is a single shielded ball bearing designed for Hyster manual pallet jack model HY55-PT. Alternate model designations include HY55-PT. It mounts on steering wheel and load wheel assemblies.

Q: What does single shielded mean on the HY 235596?
A: Single shielded means the bearing has a metal guard on one side to block large debris and moisture while allowing the bearing to breathe and shed contaminants. This design is typical for manual pallet jack wheels operating in warehouse and outdoor environments.

Q: Can the HY 235596 replace bearings from other pallet jack manufacturers?
A: The HY 235596 is a Hyster direct replacement part. While some manual pallet jack bearings may be dimensionally similar, cross-brand substitution can cause fitment problems or premature failure. Verify bore diameter, outer diameter and width match your specific equipment before using as a replacement.

Q: When should the HY 235596 bearing be replaced?
A: Replace the bearing if you hear grinding or squeaking sounds from the wheel, notice lateral wheel play, or observe visible wear. Load wheel bearings on manual pallet jacks typically last 3 to 5 years depending on use intensity and floor conditions.

Q: Is lubrication required for the HY 235596 bearing?
A: The HY 235596 is a sealed ball bearing with factory-installed grease. Once sealed, the bearing does not require periodic lubrication. If the seal is compromised or grease leaks out, the bearing must be replaced rather than re-greased.