CR 120162

Frequently Asked Questions

Q: What does the connector rod do in a pallet jack lift mechanism?
A: The CR 120162 connector rod mechanically links components in the lift arm or parallelogram mechanism. It transmits force from the hydraulic cylinder to the lift arms and maintains proper geometry during all stages of mast lift and lower cycles.

Q: Which pallet jack models does the CR 120162 fit?
A: The CR 120162 connector rod is compatible with Crown Wave electric pallet jacks. Verify your equipment model and serial range before ordering. This part is model-specific and is not interchangeable with other Crown series or competing brands.

Q: What material is this connector rod made from?
A: The CR 120162 is fabricated from hardened steel with welded joints. Material composition and diameter are engineered to handle full load cycles without bending, cracking, or joint failure under the dynamic stresses of normal pallet jack operation.

Q: What are the dimensions and load rating for the CR 120162?
A: The CR 120162 connector rod is engineered for Crown Wave equipment load capacity. Exact dimensions, diameter, and load rating are available in the product specification sheet. Using undersized or compromised rods will cause mast instability and potential structural failure.

Q: Can I use the CR 120162 on other Crown models or non-Crown equipment?
A: No. The CR 120162 is designed exclusively for Crown Wave pallet jacks. Using this rod on incompatible models will result in misalignment, binding, and accelerated wear to lift mechanism components. Always confirm exact model compatibility before installation.