Product Description
This load wheel kit is designed for heavy-duty applications, featuring durable 97A polyurethane construction that provides superior, non-marking performance. The material ensures longer-lasting wheels compared to standard 92A polyurethane, allowing for enhanced rolling efficiency when handling heavy loads.
Compatibility: Fits pallet jacks made by Raymond, model 101TF. SKU: GWK-101TF-LW-XL
Specifications
Material & Construction
| Wheel Material Composition | Polyurethane compound |
| Durometer Hardness Rating | 97-A Shore A scale |
Part Numbers & Compatibility
| Manufacturer Part Number | GWK-101TF-LW-XL |
| Compatible Equipment Model | Raymond 101TF Series Electric Pallet Truck |
Performance
| Wheel Service Type | Load-bearing wheel application for heavy-duty material handling |
Frequently Asked Questions
Q: What is the difference between GWK-101TF-LW and GWK-101TF-LW-XL?
A: GWK-101TF-LW uses 95A polyurethane wheels for lighter duty and non-marking performance. GWK-101TF-LW-XL uses 97A polyurethane XL-grade material for heavy-duty applications. The 97A is harder and lasts 20-30 percent longer. Both fit the same Raymond 101TF truck, but XL is for warehouses; standard is for retail or display floors.
Q: Will the 97A wheels damage my warehouse floors compared to standard 95A?
A: No. 97A is still a non-marking compound and will not scuff polished or carpeted floors. It is harder and more resistant to deformation, so it actually rolls flatter and reduces floor pressure. The trade-off is a slightly stiffer ride and more road noise compared to 95A, but floor safety is not compromised.
Q: Is GWK-101TF-LW-XL a direct replacement or does it require installation modifications?
A: It is a direct replacement with no modifications required. Remove the old axle pins, slide off worn wheels, install new GWK-101TF-LW-XL wheels onto the existing axles, and reinstall pins. All fasteners and axle hardware remain the same. Installation takes 30-45 minutes if wheels are not seized.
Q: How do I diagnose if my 101TF wheels need replacement?
A: Replace wheels if you notice flat spots greater than 1/8 inch deep, visible cracks or chunks missing from the polyurethane, a grinding or squealing noise during operation, or reduced steering responsiveness. If the truck pulls to one side, check for flat-spotting on that side. Also check that axles are tight; loose axles cause premature wear.
Q: What is the expected lifespan of GWK-101TF-LW-XL wheels in heavy duty use?
A: In heavy warehouse use (rough concrete, 16+ hours daily, loaded), expect 18-24 months. In moderate use (8-12 hours daily), expect 24-36 months. The 97A durometer and XL-grade material provide longer life than standard 95A. Inspect every 1000 operating hours. Replace before severe wear causes steering lag or battery drain.
Q: Do I need to rebalance the truck after installing GWK-101TF-LW-XL?
A: No rebalancing is required. The wheels are pre-manufactured to specification and designed to mount onto existing axles without any tuning. If the truck pulls or vibrates after installation, the axles may be bent or the new wheels may be seated unevenly. Check that axle pins are fully seated and fasteners are tight.