Product Description
Load Wheel Axle
Frequently Asked Questions
Q: Is the GW 216 a direct replacement for my pallet jack load wheel axle?
A: The GW 216 is a load wheel axle for standard manual pallet jacks. Verify compatibility by confirming your jack uses a 0.625 inch bore diameter and that your wheels fit the axle width range. If unsure, remove your existing axle and compare dimensions before ordering.
Q: What inspection points should I check before installing a new GW 216?
A: Inspect the wheel bore for damage or wear that could cause the axle to fail. Check that your load wheels are not cracked or flat-spotted. Verify the axle length matches the wheel width. Confirm bearings are clean and free from scoring. If any of these conditions are poor, address them before installing the new axle.
Q: What load capacity limits apply to the GW 216?
A: The GW 216 load capacity is determined by your jack frame and bearing specifications, not the axle alone. Do not exceed the nameplate load capacity of your pallet jack. Overloading causes premature bearing failure and axle bending. Always confirm the rated capacity of your complete jack assembly.
Q: How often should the GW 216 be inspected and serviced?
A: Inspect the GW 216 every 250 operating hours or monthly during regular use. Clean dirt from bearing surfaces and apply light machine oil. Check for rust, dents, or scoring on the shaft. Replace the axle if permanent deformation or spalling is visible on the bearing surfaces.
Q: Can the GW 216 be repaired if bent or damaged, or must it be replaced?
A: Bent or fractured axles cannot be straightened or welded safely and must be replaced. Even minor bending causes wheel misalignment and accelerated bearing failure. Do not attempt field repair. Order a new GW 216 to ensure safe jack operation.
Q: What is the cross-reference or equivalent part number for the GW 216?
A: No direct manufacturer cross-reference is available for the GW 216. If you need to source a substitute, contact technical support with your jack model and provide measurements of the existing axle to confirm compatibility.