EA E162

Frequently Asked Questions

Q: What material is the EA E162 O-ring made from?
A: The EA E162 O-ring is typically manufactured from EPDM or nitrile rubber, depending on your equipment model. EPDM resists oil, ozone, and weathering, while nitrile offers better resistance to mineral oils commonly found in manual pallet jack hydraulic systems. Verify your original part material before ordering to ensure chemical compatibility with your jack fluid.

Q: Which pallet jack models does the EA E162 fit?
A: The EA E162 fits Eagleman manual pallet jacks using the O-RING seal model. Alternate model designations include ORING and O RING. Cross-check your equipment nameplate to confirm the seal assembly uses this part number or one of the alternate model numbers before ordering.

Q: What is the typical lifespan of an O-ring before replacement?
A: O-ring lifespan depends on usage frequency and storage conditions. In normal warehouse environments, expect 2 to 5 years before degradation occurs. Exposure to extreme heat, direct sunlight, or incompatible fluids reduces lifespan significantly. Replace immediately if you observe swelling, hardening, cracking, or persistent fluid weeping around the seal area.

Q: How do I know if the EA E162 O-ring has failed?
A: Signs of O-ring failure include visible hydraulic fluid pooling beneath the jack, reduced lift pressure or jerky operation, and a slow descent under load. If the jack loses pressure between uses, the O-ring seal is likely compromised. Do not continue operation; replace the seal to prevent hydraulic system damage.

Q: What dimensions should I verify before ordering the EA E162?
A: O-ring specifications are defined by inner diameter (ID), outer diameter (OD), and thickness. Verify your current O-ring size matches EA E162 specs before ordering. Using an oversized or undersized ring will not seal properly and will leak. Check your equipment manual or measure the existing seal if documentation is unavailable.