Product Description
OD: 3.740 inch or 95MM; ID: 2.362 inch or 60MM; Width: 0.708 inch or 18MM
Frequently Asked Questions
Q: What are the dimensions of the BS 6012 2RS bearing?
A: The BS 6012 2RS has an outer diameter of 3.740 inches (95MM), an inner diameter of 2.362 inches (60MM), and a width of 0.708 inches (18MM). These dimensions fit a range of electric and manual pallet jack models from Crown, Toyota, Raymond, and other major manufacturers.
Q: What does the 2RS designation mean on this bearing?
A: The 2RS designation indicates the bearing has two rubber seals on both sides. These seals provide protection against dirt, moisture, and contamination, making the bearing suitable for warehouse, dock, and outdoor material handling environments.
Q: How long does the BS 6012 2RS bearing typically last?
A: The lifespan depends on load capacity, operating conditions, and maintenance. In standard indoor warehouse operations with proper lubrication, expect 2000 to 3000 operating hours. Wet floor or cold storage environments may reduce lifespan to 1500 to 2000 hours due to increased seal wear.
Q: Can I use the BS 6012 2RS as a direct replacement for other bearing sizes?
A: No. The BS 6012 2RS dimensions must match exactly with your equipment. Verify the outer diameter (3.740 inches), inner diameter (2.362 inches), and width (0.708 inches) before ordering. Using an incorrectly sized bearing will cause improper fit, reduced load capacity, and premature failure.
Q: Is the BS 6012 2RS suitable for wet or cold storage environments?
A: Yes. The 2RS rubber seals provide moisture protection, making this bearing suitable for wet floors. However, in cold storage below 0°F, the rubber seals may become stiff. For consistent operation in freezer environments, consider alternative bearing compounds or more frequent maintenance.
Q: What is the load capacity of the BS 6012 2RS?
A: The BS 6012 2RS is a deep-groove ball bearing rated for radial loads up to 1540 lbs and thrust loads up to 920 lbs. Actual capacity depends on speed and operating temperature. Do not exceed 60% of rated load for extended service life in material handling applications.