RA 632-108-SPS

Frequently Asked Questions

Q: What does press-on mount configuration mean for the RA 632-108-SPS tire?
A: Press-on mount means the polyurethane tire is mechanically pressed onto a separate cast iron or steel hub using hydraulic or arbor press equipment. The tire and hub are not bonded or glued. This modular design allows tire replacement without replacing the hub, reducing total cost per tire cycle.

Q: Which Raymond equipment models is the RA 632-108-SPS compatible with?
A: The RA 632-108-SPS is a press-on tire assembly used on Raymond electric reach trucks and orderpickers. Verify compatibility with your specific equipment serial number and model year. Raymond model ranges vary widely; confirm wheel diameter, hub bore, and tread width match before ordering.

Q: Is a separate hub component required when ordering the RA 632-108-SPS replacement tire?
A: The RA 632-108-SPS is typically a tire-only component. If the existing hub is damaged, cracked, or worn, it must be replaced separately. Request the corresponding hub assembly part number when placing your order. Check the OEM documentation for cross-reference and assembly compatibility.

Q: What material is the RA 632-108-SPS tire manufactured from?
A: The RA 632-108-SPS is manufactured from polyurethane, typically a medium-durometer compound suitable for indoor warehouse operation on clean concrete floors. The exact durometer rating and tread profile depend on the specific variant. Review the part specifications sheet for material composition and performance characteristics.

Q: What is the maintenance and removal procedure for a press-on tire like the RA 632-108-SPS?
A: We do not provide installation, removal, or maintenance procedures. Tire removal requires specialized hydraulic or mechanical press equipment. Contact a service technician or authorized service center for press-on tire replacement. Improper removal may damage the hub or cause injury.