Product Description
The GW 327-N Steer Wheel Assembly is designed specifically for manual pallet jack applications. Manufactured by Liftsplus.com, this component features a durable nylon thermoplastic wheel, making it an ideal direct replacement for compatible manual pallet trucks.
Specifications: 8.000 inch diameter x 2.000 inch width (8.000" x 2.000" | 8 x 2 wheel | 8 x 2 | 203.20mm x 50.80mm) | Bearing ID: 20mm (0.787 inch bore | 20.000mm ID)
• Constructed from high-quality nylon thermoplastic for enhanced durability
• Engineered for smooth operation and reliable performance
• Easy to install as a direct replacement for existing wheels
This steer wheel assembly is compatible with various manual pallet truck models, ensuring seamless integration and optimal functionality.
Specifications
Part Numbers
| Manufacturer Part Number | GW 327-N |
| OEM Part Number | GW 327-N |
Wheel Dimensions
| Outside Diameter | 8 |
| Width Side to Side | 2 |
Frequently Asked Questions
Q: Is GW 327-N the official OEM part number for this wheel assembly?
A: Yes. GW 327-N is the manufacturer OEM part number and the primary specification for this steer wheel assembly. When ordering replacements for your manual pallet jack, use GW 327-N to ensure you receive the exact engineered component. This part number is cross-referenced on most manual pallet truck documentation as the correct rear steer wheel replacement.
Q: How does nylon thermoplastic construction differ from standard nylon in the GW 327-N?
A: Nylon thermoplastic is a molded engineering polymer that combines the durability of traditional nylon with improved temperature stability and impact resistance. GW 327-N uses this material for enhanced performance across warehouse temperature ranges (below-zero to warm storage environments). Thermoplastic construction resists brittle failure in cold conditions and maintains structural integrity longer than standard nylon wheels.
Q: What bearing configuration is included with the GW 327-N assembly?
A: The GW 327-N includes sealed ball bearings mounted on a 20mm bearing ID. The assembly is supplied with bearings pre-installed and sealed; no field service or lubrication is required. The bearing ID (inside diameter) is 20 millimeters, matching standard pallet jack axle shafts. Verify your axle shaft diameter is 20mm before installation.
Q: Can the GW 327-N be retrofitted to an older manual pallet jack model?
A: Yes, the GW 327-N can replace any manual pallet jack steer wheel position where the axle shaft diameter is 20mm and the original wheel mounting position is 8 inches outside diameter x 2 inches width. However, confirm your jack model year and serial range in your equipment documentation before purchase. Some jack generations use different bearing IDs or mounting methods; fitment is not guaranteed without verification.
Q: What is the installation procedure for the GW 327-N wheel assembly?
A: Secure the jack on a flat, level surface. Remove the retaining bolt, cotter pin, or clip holding the worn wheel assembly on the axle. Slide the old wheel off the axle shaft. Align the GW 327-N assembly onto the axle and slide it fully onto the shaft until the hub seats against any integral shoulder. Reinstall the retaining fastener and tighten to prevent axial movement. Rotate the wheel by hand to ensure smooth, quiet operation.
Q: How long does the GW 327-N typically last in normal warehouse service?
A: The GW 327-N is engineered for 18 to 24 months of continuous warehouse use under normal load cycling (25 to 50 lifts per day). Lifespan depends heavily on floor conditions, load consistency, and steering angle frequency. Smooth, well-maintained floors extend service life. Rough concrete floors, high-angle steering, and load impacts reduce wheel life. Inspect quarterly and replace if bearing noise develops or wheel surface shows flat spotting.