Product Description
Steer Wheel Axle
Frequently Asked Questions
Q: What manual pallet jack models does GW 417 steer wheel axle fit?
A: GW 417 is a steer wheel axle assembly for standard manual pallet jacks. Verify your jack model and serial range against the GW 417 specification sheet before ordering. Cross-reference with equivalent parts from Yale and Crown to confirm compatibility with your specific frame width and bearing type.
Q: How do I know when GW 417 steer wheel axle needs replacement?
A: Replace the GW 417 if you observe hard steering, grinding noise during turns, visible wheel wobble at the steering end, or excessive play (more than 0.125 inches) when you grasp the wheel and move it side-to-side. These symptoms indicate bearing wear or axle bending.
Q: Is GW 417 steer wheel axle installation plug-and-play?
A: GW 417 installation requires removing the steering wheel, unbolting the old axle assembly, and pressing the new one into the frame. You will need a arbor press and alignment pins. Do not attempt removal without proper tooling, as improper press angle can damage the frame.
Q: What is the load capacity of GW 417 steer wheel axle?
A: GW 417 is rated for the standard manual pallet jack load capacity of 5500 pounds. Do not exceed this limit. The axle assembly handles only steering forces, not lift load; overloading causes bearing premature failure.
Q: How often should GW 417 steer wheel axle be serviced?
A: Inspect GW 417 bearings and axle alignment every 500 operating hours or twice yearly. Relubricate sealed bearings per your jack manual. If bearings are not sealed, apply light machine oil every 250 hours. Most axle assemblies last 3000 to 5000 operating hours before bearing failure.