Product Description
Poly x-groove d/t w/hub
Specifications: 9.000 inch diameter x 5.000 inch width (9.000" x 5.000" | 9 x 5 wheel | 9 x 5-0/0 | 228.60mm x 127.00mm)
Specifications
Wheel Specifications
| Outside Diameter (in) | 9.000 |
| Width (in) | 5.000 |
| Outside Diameter (mm) | 228.60 |
| Width (mm) | 127.00 |
| Drive Tire Profile | Smooth Flat |
| Tread Style | X-Groove |
| Material | Polyurethane |
Frequently Asked Questions
Q: What is included in this X-Groove tire with hub assembly?
A: The SU 9X5X5-SF-P-XGROOVE-A is a complete assembly with the X-Groove polyurethane tire factory-bonded to a pre-mounted hub. The tire is 9.000 inches outside diameter by 5.000 inches width. No heat pressing or tire installation is required. Simply bolt the assembly to your equipment shaft using the hub mounting holes.
Q: How does this assembly perform on inclines or sloped floors?
A: The X-Groove tread pattern provides superior traction on ramps and sloped surfaces compared to smooth flat tires. The diagonal grooves bite into the floor surface, reducing wheel slip when operating at angles. This assembly is rated for 3020 lbs capacity at 6 mph on all floor conditions within its rated limits. For maximum safety on steep inclines, reduce load and speed.
Q: Can I switch between smooth and X-Groove tires on my equipment?
A: Yes. Both the smooth SU 9X5X5-SF-P-A and X-Groove SU 9X5X5-SF-P-XGROOVE-A assemblies have identical 9.000 x 5.000 inch dimensions and 5.000 inch bore. You can swap between assemblies without modification. However, mix smooth and X-Groove tires on the same equipment only if you understand the handling differences. Matching tire types front and rear is recommended for balanced traction.
Q: What is the installation procedure for this hub assembly?
A: Clean the hub mounting surface on your equipment. Slide the assembly onto your equipment shaft, aligning the hub bore with the shaft. Install and tighten all mounting bolts evenly in a cross or star pattern to specification, typically 40 to 60 foot-pounds depending on your equipment manual. Do not overtighten bolts as this can crack the hub or strip threads. No heat or pressing is required.
Q: How do I maintain the X-Groove pattern in this assembly?
A: Clean grooves weekly with a stiff brush to remove floor debris and dust accumulation, which reduces traction. Do not use high-pressure washers as water forcing into grooves can cause tire delamination from the hub. Inspect grooves monthly for tears, cracks, or rubber chunks. If groove walls show damage or if grooves fill with wear material, replace the assembly. Normal lifespan is 2 to 4 years depending on usage.