Product Description
Wesco GWK-WIC1-CK complete wheel replacement kit designed for manual pallet jack model 272748. Kit features dual Ultra-Poly load roller assemblies with 70 durometer polyurethane measuring 3 inches diameter by 3.375 inches width, dual polyurethane steer wheel assemblies with precision roller bearings, heat-treated steel axle shafts, and complete fastener hardware. All components pre-assembled for direct installation. Black polyurethane finish on all wheel surfaces.
Compatibility: Fits pallet jacks made by Wesco, model 272748. SKU: GWK-WIC1-CK
Specifications
Compatibility
| Compatible Models | Wesco Model 272748 |
Kit Contents
| Load Roller Assemblies | Dual Ultra-Poly units |
| Steer Wheel Assemblies | Dual units with precision roller bearings |
| Axle Shafts | Heat-treated steel |
| Fastener Hardware | Complete set included |
| Assembly Status | Pre-assembled |
Specifications
| Load Wheel Diameter | 3 inches |
| Load Wheel Width | 3.375 inches |
| Durometer Rating | 70 |
| Wheel Material | Polyurethane tread and hub |
| Finish | Black polyurethane |
| Part Number | 0000-72008 |
Frequently Asked Questions
Q: Does GWK-WIC1-CK fit Wesco model 272748 pallet jacks?
A: Yes. GWK-WIC1-CK is the complete wheel replacement kit designed specifically for Wesco manual pallet jack model 272748. This is a full kit replacement and includes all load rollers, steer wheels, bearings, axles, and fasteners. Verify your jack model number on the nameplate before ordering.
Q: What is included in the GWK-WIC1-CK complete wheel kit?
A: GWK-WIC1-CK includes dual ultra-poly load roller assemblies (3 inch diameter by 3.375 inch width, 70 durometer), dual steer wheel assemblies with precision roller bearings, heat-treated steel axle shafts, and complete fastener hardware. All wheels come pre-assembled and ready for direct installation. Black polyurethane finish is standard.
Q: Do I need to disassemble or modify anything to install GWK-WIC1-CK?
A: No. GWK-WIC1-CK is a plug-and-play replacement. Remove your old wheel assemblies using a socket wrench. Install the new pre-assembled units in place and tighten fasteners firmly. If your jack is 3+ years old, inspect the steering column and load frame for damage before installation. Installation time is typically 15-30 minutes per jack.
Q: What maintenance is required after installing GWK-WIC1-CK?
A: After installation, run the jack through a full load-and-lower cycle 5 times with no load. Check that all fasteners remain tight and that wheels roll smoothly without binding or noise. Inspect monthly for debris wrapped around axles. Do not lubricate polyurethane wheels; sealed bearings do not require additional grease. Recheck fasteners after the first week of operation.
Q: How long does GWK-WIC1-CK typically last before replacement?
A: Under normal warehouse duty (8-10 hours per day), GWK-WIC1-CK wheels last 2-4 years before visible wear requires replacement. In continuous-duty environments or on rough floors, expect 12-18 months. Bearing failures may occur earlier if the jack is overloaded or exposed to moisture. Check for flat spots and uneven wear every 6 months.