Axle Bushing for Bearings

Frequently Asked Questions

Q: What are the dimensions of the CA GPS-3/4-1/2X2-7/16 axle bushing?
A: The CA GPS-3/4-1/2X2-7/16 bushing has an outer diameter of 3/4 inch, inner diameter of 1/2 inch, and a length of 2-7/16 inches. This bushing serves as a wear sleeve between the axle shaft and wheel hub on material handling equipment.

Q: Which axle sizes and equipment does this bushing fit?
A: This bushing is designed for 1/2 inch diameter axles and fits load wheels on pallet jacks, hand trucks, and carts from Crown, Toyota, Raymond, Yale, Hyster, and Jungheinrich. Confirm outer diameter and axle bore match before ordering to ensure proper fit.

Q: What material is this bushing made from and why?
A: The CA GPS-3/4-1/2X2-7/16 is typically manufactured from bronze or composite bearing material. These materials provide low-friction rotation against steel axles and resist wear under continuous use. Composite bushings also resist rust and perform well in wet storage environments.

Q: How long does this bushing typically last?
A: Under normal operating conditions, this bushing typically lasts 3 to 6 years depending on load frequency and environment. High-use environments and wet or cold storage may reduce service life to 2 to 3 years. Proper axle lubrication extends bushing longevity.

Q: What are the signs that this bushing needs replacement?
A: Signs of bushing wear include wheel wobble or play, grinding or squeaking sounds from the wheel hub, increased friction during wheel rotation, and visible gap between the bushing and wheel. If the wheel spins rough or with hesitation, bushing wear is likely present.

Q: Is this bushing compatible with aftermarket wheels?
A: This bushing fits any wheel assembly with a 1/2 inch axle bore and compatible mounting configuration. Cross-reference dimensions and axle diameter with your specific equipment to verify compatibility before purchase.